What problems should be paid attention to in the processing of cnc parts?

Lemo specializes in cnc machining processing, CNC turning ,CNC milling and so on. This article introduces you to What problems should be paid attention to in the processing of cnc parts?1. Must comply with the processing center safety procedures.2. Before work, wear protective equipment and tie the cuffs. Do not wear scarves, gloves, ties, or aprons. Women workers should wear them in their hats.3. Check whether the tool compensation, machine zero, workpiece zero, etc. are correct before starting.4. The relative position of each button should meet the operational requirements. Carefully prepare and input the NC program.5. Check the operation status of hungry protection, insurance, signal, position, mechanical transmission part, electrical and hydraulic digital Display on the equipment, and cut it under all normal conditions.6.Before the machine tool test run, should check the lubrication, mechanical, electrical, hydraulic, digital display and other systems operating conditions, under all normal conditions can be cut.7. After the machine tool enters the machining operation according to the program, the operator is not allowed to contact the workpiece, the tool and the transmission part of the athlete. It is forbidden to transfer or take tools and other items through the transmission part of the machine tool.8 When adjusting the machine, clamping the workpiece and tool, and wiping the machine, it must be stopped.9. Tools or other items must not be placed on appliances, operating cabinets and protective covers.10. Do not remove the iron filings directly by hand. Use special tools to clean.11. If abnormal conditions and alarm signals are found, stop immediately and ask the relevant personnel to check. Cnc Machining center12. It is not allowed to leave the job when the machine is turned. If you want to leave, put the workbench in the middle position, the knife bar will be returned, you must stop, and cut off the power of the host.The condition for the CNC machining parallel line method is that the plain lines on the surface of the member are parallel to each other and reflect the real length on the projection surface. 
Lemo has over 40 CNC machining centers, include 3 axis,4 axis , 5 axis.We are expert on CNC machining ,CNC milling, CNC turning processing, precision grinding
 pls conttact us as below :Amy ChenDongguan Lemo Precision Metal Products Co.,LtdDirect Phone: 86-137 1326 2409
Skype: amyptjEmail: [email protected]: www.ptjmachining.comPrevious: How to divide the CNC machining processNext: Problems caused by improper arrangement of cnc processing technology

Link to this article:What problems should be paid attention to in the processing of cnc parts?

Reprint Statement: If there are no special instructions, all articles on this site are original. Please indicate the source for reprinting:Mold Wiki,Thanks

Related Posts